Funds raised for DIY EEG project.

Robert found some likeminded brains:


"We put together an EEG kit for a workshop we held on the 25th "teaching people to integrate EEGs into Art". We were pretty amazed at peoples response in actually being able to see their brainwaves. We'd like to share that amazement with as many people as we can. While I think I'm a pretty swell teacher, I realize that physically we can't hold a workshop for everyone. And so the next best thing would be to offer the EEG as an affordable Kit. 

TL;DR: We'd like to use this kickstarter to spread our love for EEGs and more generally Neuroscience, in the form of an easily put together kit."

We should perhaps consider following their approach to funding.

Fixing bluetooth connection

As it turned out the BlueSmirf Bluetooth module by default listened at 57600 baud, while the microcontroller was sending out bits at 115200 baud. Sending commands using Putty to change the baudrate solved the problem  (but not after also discovering a defective flatcable connecting the two board. Always make your own!)

http://www.sparkfun.com/datasheets/Wireless/Bluetooth/rn-bluetooth-um.pdf

Proposal for making Lucy famous

(note the cardboard experimental setup)

screenshot realtime analysis

First measurement

Making the Pod

Two AA doublecell cylindrical battery holders

(6,14 Euro a piece) 
for four 2700 mAh batteries, 1.2 Volts
(5,20 Euro a piece)

Making holes in casing with perforator

for battery holders

Drilling holes for bolts

Attaching batteryholders 
with plastic screws and bolts

Amazing job aligning and drilling the holes 

with "the puncher"

Note the spacing: two bipolar leads and one DRL

(Right Leg Driver)

Back of front panel

Always use shrinkwraps to prevent 

short circuit when box is closed.

5x Touchproof jacks 1.5 mm contact

7.9 mm thread diameter, from MedCat

(25 Euro for 10)

On / Off switch wired to battery

Rewiring board LED

With a little red lens

Beautiful!

Replacement LED stuck into lens

Front panel, casing, battery & board

Wired touchproof sockets to EEG/DRL

Back of front panel

Double sided tape to attach LED

Sandwich boards with stack screws

USB breakout board attached on

floor with plastic screws and bolts

Drilled and filed hole socket for connection

Attached boards to floor of casing

with screws and bolts

Bluetooth BlueSmirf breakout board

Strapped with tiewrap to battery holder

(60 Euro)

Closing the casing after cleaning up 

wires with tiewraps

Removing the plastic protection of

aluminium front and turning it on!